Products

1.0 – Cleaning Products

Our cleaning products are made of nylon fibers and coarse silcon carbide abrasive grain. They create an open and flexible web that resists loading. The material does not get caught, and runs much cooler than wire brushes. The material cleans only the surface without damaging the workpiece. It can also be used on almost any material.

1.2 | Cleaning Wheels

This product group is currently being established.

1.3 | Cleaning Rolls

This product group is currently being established.

Application areas & guidance notes

Primarily for procedures such as removing

  • Seals
  • Sealant residues
  • Anti-chip coatings
  • Rust
  • Algae
  • Paint layers

REX Cleaning Products demonstrates the full range of its performance capabilities especially on hard alloys, such as stainless steel weld seams, or when removing heat tint. So feel free to challenge our products to the utmost!

These products are recommended for use on regulatable angle-grinders.

Nylon fibres starts to melt at excessively high rotation speeds and under heavy press force. Depending on the disc diameter, the ideal range is between 3000 and 7000 rpm. That corresponds to a circumferential velocity of approximately 37 m/s.